07/06/2016–21/10/2016 Electronics engineer ARKE'S, Catania (Italy) Study and design of solutions finalized at energy saving

20/07/2015–26/03/2016 Trainee STMicroelectronics, Catania (Italy) Design a trimming offset within a humidity sensor.

01/06/2015–15/10/2015 Student University of Catania, Catania Collaboration with the University of Catania in a project for the STMicroelectronics company, based on an innovative technique to the transfer and transduction energy , designed to operate completely off devices or who are not in a state of stand-by.

EDUCATION AND TRAINING

15/10/2010–25/03/2014 Bachelor's Degree in Electronic Engineering University of Catania, Catania (Italy) The thesis entitled "Amplifier three stages of gain with Reversed Nested Miller Compensation" concerns the analysis and design of a three-stage amplifier that can allow, in a simple and effective mode , to obtain a high gain with a low supply voltage. Supervisor: Prof. G. Giustolisi. Degree mark: 103/110. Tool: LTspice

10/10/2014–29/03/2016 Master's degree in Electronic Engineering University of Catania, Catania (Italy) The thesis entitled "Compensation of the offset into capacitive sensor" regards the analysis and optimization in terms of area and performance of an offset trimming used in a SC amplifier chain of a capacitive sensor. Supervisor: Prof. A. Grasso (University of Catania) and Ing. M. Vaiana (STMicroelectronics). Tool : Cadence Virtuoso. Degree mark: 107/110.

PERSONAL SKILLS Mother tongue(s) Italian

Other language(s) English A2

Communication skills The different experiences in the laboratory and in the company have enabled the acquisition of good relational skills with people around me. I am able to communicate clearly and accurately, responding to specific requests.

Organisational / managerial skills I'm able to independently organize the work, setting priorities and taking responsibility acquired through different professional experiences listed above in which I have always been required to independently manage different activities according to the deadlines and objectives.

Job-related skills I have a good knowledge of microelectronics and software to design a circuit, thanks to the university laboratories and experience in the company during the internship. I have a good basis electrical systems and home automation. I'm able to use the following technical programs: LT Spice, PS Spice, LabView, Matlab, C ++, Dev-C+ + , Eagle, Cadence Virtuoso(Eldo simulator).